LOAD SENSOR 50KG

Load Cell 50kg

These load cells operate at minute voltage changes and they need an amplifier board to hook them up to a microcontroller like an Arduino.

Features:

The internal 1000 ohm half bridge strain gauge, the measuring range is 50kg weighing sensor, half bridge structure.
This sensor can be used in 3 methods:
using a sensor with an external resistance to form a full bridge measurement, range with a single sensor: 50kg. External resistance must be higher.
using two sensors to form a full bridge measurement, the range of two sensors is: 50kgx2=100kg
using four sensors to form a full bridge measurement, the range of four sensors is: 50kgx4=200kg
Capacity: 50kg
Comprehensive: 0.10 %FS
Output Sensitivity: 1 +/- 15% mV/V
Non-linearity: 0.05 %F.S
Repeatability: 0.05 %F.S
Hysteresis: 0.05 %F.S
Zero Output: +/- 0.3 mV/V
Creep (1min): 0.1 %F.S
Zero Drift (1 min): 0.1 %F.S
Temp Effect on Zero: 0.3 %F.S/10
Temp Effect on Output: 0.1 %F.S/10
Input Resistance: 1000 +/- 10 Ohms
Output Resistance: 1000 +/- 10 Ohms
Insulation Resistance: greater than 2000M
Excitation Voltage: 10VDC
Operating Temperature: -10C to +50C
Overload Capacity: 150 %F.S
Working Voltage: 5V
When measuring, the force should be applied to the outer side of the strain E-shaped portion of the sensor ans the outside edges to form a shearing force in the opposite direction (i.e., the middle of the metal beam should bend with the center affixed to the strain gauge. Make sure that there is a shearing force across the center and edges when weight is applied for a proper reading.)